Citation: | CHENG Ying, WANG Jia-wu. Numerical simulation and optimization of the cylinder head water jacket based on the two-phase flow boiling heat transfer[J].JOURNAL OF BEIJING INSTITUTE OF TECHNOLOGY, 2015, 24(3): 328-334.doi:10.15918/j.jbit1004-0579.201524.0307 |
[1] |
Bo T. CFD homogeneous mixing flow modelling to simulate sub-cooled nucleate boiling flow, SAE paper 2004-0l-1512[R]. Warrendale, PA, USA: Society of Automotive Engineering, 2004.
|
[2] |
Berezhkovskii L M, Zitserman V Y. Multidimesional theroy of homogeneous boiling of pure liquids[J]. Colloid and Interface Science, 1993,156(1):153-156.
|
[3] |
Kurul N, Podowski M Z. On the modeling of multidimensional effects in boiling channels[C]//ANS Proc. 27th National Heat Transfer Conference, Minneapolis, MN, USA, 1991.
|
[4] |
ANSYS Inc. ANSYS CFX-Solver theory guide[M]. Canonsburg, PA, USA: ANSYS Inc, 2009.
|
[5] |
Yao Xiugong, Chen Ying, Gai Hongwu. Simulation and analysis of thermal load for diesel cylinder head[J]. Vehicle Engine, 2003(1):61-65. (in Chinese)
|
[6] |
Sato Y, Sadatomi M, Sekoguchi K. Momentum and heat transfer in two-phase bubble flow[J]. International Journal of Multiphase Flow, 1981, 7(2):167-177.
|
[7] |
Erfeng Chen, Yanzhong Li, Xianghua Cheng. CFD simulation of upward subcooled boiling flow of refrigerant-113 using the two-fluid model[J]. Applied Thermal Engineering, 2009, 29(11/12):2508-2517.
|
[8] |
Yang Shiming, Tao Wenquan. Heat transfer[M]. Beijing: Higher Education Press, 2006: 301-335. (in Chinese)
|
[9] |
Pan Lijun, Cheng Jingquan. Expermental design & date processing[M].Nanjing: Southeast University Press,2008:73-87.(in Chinese)
|